|
Blue Spring Corporation is the pioneer (1982) in commercialization of reverse osmosis technology for the production of pharmaceutical USP water. Now, with the addition of the latest electrodeionization (EDI) technology, and a storage-tank-less re-circulating output loop feature, the new breed of BLUE SPRING WP-EDI Series pharmaceutical water purification systems produce even higher quality pharmaceutical grade water which surpasses the latest USP 29 standards for purified water for pharmaceutical uses.
When you go with Blue Spring, you are in safe hands !
UNIQUE FEATURES
- Exceptional Quality USP Purified Water: Typical output water measures 0.3-1.2 mS/cm electrical conductivity, 150-250 ppb TOC, 1-10 cfu/ml bacteria content. Meets USP 29 and other international standards
- Exceptionally Consistent Purified Water Quality: Replacement of conventional de-ionizing resin beds with electrodeionizing modules (EDI) results in extremely consistent purified water quality and lower ion content
- Exceptional Economy: Costs fraction of conventional USP purified water systems to purchase, to operate and to maintain
- Exceptionally Space-Saving Design: Small 76 cm x 146 cm footprint for 1,600 L/hr capacity unit
- Sanitary Construction: Fully enclosed inside stainless-steel cabinet. High-purity, low-extractable PVC output piping better than PVDF or stainless-steel. Cold-sterilizable with internal cleaning and sanitizing system
- Ultimate Contamination Control: Totally Sealed System prevents infusion of environmental contaminants.
purified water distribution system (see below). Unused Purified water from production area is continuously recycled to water purification section where it gets repeatedly purified with every pass. Continuously purges out bacteria generated in pipelines instead of accumulating them, as in conventional delivery systems.
- Exceptionally Simplified Distribution System Design: Only a few passive piping components required for completing delivery system. No storage tanks, no breathing filters, no re-circulation pumps, no UV lights, no sub-micron filters, no heat exchangers, no clean steam generators required.
- Water-Saving Design: 60-70% overall water recovery.
- Energy-Saving Design: High-efficiency EDI power supply. Cold re-circulation loop. Only 2.4 watt.hours of total energy consumption per liter of purified water, including delivery system.
- Environmentally Friendly Design: No chemicals used to regenerate de-ionizing resins. No chemical discharge to sewer other than impurities present in source water
- Easy Installation: Integrated RO/EDI design for Plug-n-Go installation. Only delivery loop passive piping required to complete installation
- Easy Validation: Factory-assembled, factory-validated water purification unit simplifies on-site validation of water system. OQ and PQ certification provided with each system
- Easy Operation: Single-switch daily operation with manual over-ride. Quick stabilization avoids 24/7 operation. Ergonomic instrumentation and control panel
- Easy Sanitizing: Single-shot sanitizing of water purification unit and the distribution piping with built-in cleaning and sanitizing system.
- Easy Maintenance: Only single moving part (RO pump) in the entire water system installation including delivery piping. Single circuit board electronics for all instrumentation. Integrated EDI power supply. Very few things to break down.
|
|
